How do I configure your wifi extender?


Wifi extender enables users to get the smartest home in the community through new networking technologies. These have various advantages such as watching stream videos with less buffering time, watch most of the stuff on the tablet without buffering, check in from home, store and preserve all of your family’s memories. From the most current wireless Internet access to the most innovative streaming and storage technologies, your home network device will have the speed, coverage and performance you need whenever you need it. We are dedicated to creating a pleasant user experience so that you can focus on other tasks. Linksys Extender Setup is the one of the best brand in market

An extender is a device which extends your wifi transmission range and can help you increase your wifi range from one room to another.

How to set it up?

  • Before using, make sure that the product is plugged in to a power source.

  • In fact, the Wi-Fi router needs to be near the AKiTiO Cloud icon so they can be connected to each other.

  • Installation of all of your Wi-Fi devices will increase the length of your Wi-Fi signal.

  • You can enjoy improved wireless networking in every room by using cordless phones.

  • You can go to for further specifications.

Determine Network Settings.

An extender increases the speed and range of your existing network. Wi-Fi is normally used for small mobile devices and home computers to access the Internet.

How to install the router into the computer?

Remove the antenna caps from the side of the clock. Make sure that the antenna is connected to its tower correctly.

Attach the extender to the router and turn it on. After that, change the security configuration of the extender and configure its Wi-Fi operation through WPS button.

After turning the wifi extender on, press the button three times and wait for the light bar to blink green.

After about a minute, the users should be connected.

How to use?

  • Container facilitates the circuit elements.

  • • Attach the antenna and the telemetry unit.

  • Let your modem be ready for the attached file.

  • The modem must be connected to the power source.

Tom Wilson

Leave a Comment

error: Content is protected !!